TNTCO X ZEUS Assembly Instructions

1. Handlebars

Align and insert the handlebars into front fork.

Loosely tighten the handlebar clamp, and adjust the height of the handlebar to riders comfort.

Tighten the handlebar clamp making sure the clamp is tightly secured, and handlebars do not move.

2. Pedals

identify the left and right markings on the pedals. Be sure to install the pedals on their respective side. L and R indicators are located on the underside of pedals.

(left pedal tighten counter-clockwise to install)

While keeping the pedal horizontal, carefully hand-start the threads of the pedal into the crank arm.

Finish tightening the pedals using the supplied 15 mm wrench. The pedals must be very tight. Check and retighten the pedals after your first two rides.

3. Mud Guard

Place mud guard below lower crossbar of the front fork.

Insert and secure bolt with hex wrench. Bolt must be very tight to prevent rattling.

4.Connect

Connect the red higo plug to controller by aligning arrows on both ends and pushing into place. The headlight is ready for use.

5. Battery

Slide battery into mount and push until it clicks.

6. Lock The Battery

Insert and turn key to lock in place.

(Make sure to lock the battery and remove the key before riding)

Power on the battery and enjoy your ride.